You can add a vanishing point to the ruler to match the shape of the fisheye.ġ. It reduces surface tension of the wet paint film improves flow-out.
You can also enable snapping to the ruler or grid to help in your drawing. Our Custom Shop KE215-HP Fisheye Eliminator Additive prevents fisheyes and increases gloss. You can adjust the guide lines and vanishing point according to what you want to draw. The lower right controller lets you turn the snap function on and off. The upper left controller changes the position of the controller to move the entire ruler. Do not use fisheye eliminator in undercoats or basecoat color. You can also use fisheye eliminator as an additive but follow the instructions carefully. A previous paint job may even have used silicon-heavy additives that are causing fisheye to occur. If fisheyes appear in a basecoat, allow the color to dry then spray a mist coat over affected area. Silicon, dirt, wax, and grease particles can come from surface cleaners, rags, food, the air, equipment lines, etc. You can change the position and angel of the eye level (blue).Ĭhange the position of the eye level with the central controller and change the angle by moving the small controllers on the sides.Ī vanishing point snapped to above the eye level will also be moved if you move the eye level.Īs outlined in “Adjusting the fisheye distortion,” you can move the entire fisheye perspective ruler position. To avoid paint bubbles before painting, thoroughly clean the surface with detergent and hot water, followed by a solvent cleaner. You cannot move the controller outside the lens circle.ĭrag the controller to change the center of the fisheye lens. The snap function can be switched on and off with the square controller on the lower right of the white circle. You can change the slope of the angle of the guide line by dragging the blue circles at both ends. If the fisheye isnt too bad, put a light coat on, let it tack up and keep adding light coats till you get it covered, then put a heavier coat on. Drag and move the middle white circle to move the guide lines. Re: fish eyes in paint in reply to dick benson, 03-24-2015 13:17:33 Its usually caused by some oil residue, wax or silicone on the work.
0 kommentar(er)
